STUDIO BRIEF 02
TOTE BAG DESIGN
ART WORK PREPARATION:
First I created the outlines of the design, this has to be done for the laser cutter to be able to read the design.
As it is a vinyl transfer the text needs to be mirrored I did this on Illustrator so the text reads backwards, when the vinyl is transferred it will read the right way up.
VINYL CUTTING:
Unfortunately the vinyl cutter hadn't been set properly so i had to go over the engraved lines with a scalpel to make sure they were cut all the way through before pealing off the excess vinyl. This proved difficult as it was hard to see where the lines were.
HEAT PRESS:
No comments:
Post a Comment